Aspire Spryte 650mAh 3.5ml All-In-One Kit
- 1 x Spryte device
- 2 x Extra O rings
- 1 x 1.8Ω regular BVC coil
- 1 x 1.2Ω for Nic Salt coil
- 1 x Silicone seal
- 1 x Micro USB Cable
- 1 x Warranty Card
- 1 x User Manual
Aspire Spryte AIO Kit
Another great AIO pod system from Aspire the Aspire Spryte, an all new design pod system, slim and stylish it comes in 5 popular, satin finish, stylish colors: olive green, grey, black, blue and pink. The Spryte has an easy to fill 3.5 or 2ml pod, it fits comfortably in the hand in use and is very discreet. It utilizes Aspire’s well known BVC coils and comes with a regular 1.8ohm coil and a second one 1.2ohm for use with nicotine salts.
The Sprtye's sleek minimalist design fits well in pocket or purse and the protective top cap fits snugly on to the bottom of the device when in use.
Adjustable Airflow System
Unusually for an AIO pod device of this type, the Aspire Spryte has an adjustable airflow system to suit your vaping preferences.
Regular and Nicotine Salt Atomizer
The Aspire Spryte atomizer is the well known and trusted BVC coil and uses nichrome wire. The Spryte comes supplied with two coils, one for regular e-liquid and one for use with nicotine salts, though it works equally well with normal e-liquids.
Aspire Spryte Pod
The pod in the Spire Sprtye is an easy to use pull-out & push-and-click system. It's bottom fill using a simple but effective silicone plug in the base of the pod, with a generous 4.6mm filling hole, to suit all types of e-liquid bottle.
Coil Installation
Whatever type of coil you use, the standard BVC or the nic-salts BVC, both are easy to install. Simply remove the pod and turn it upside down, remove the chimney unit and screw in your chosen coil. Replace the chimney unit with attached coil and reinsert into the pod. Push the pod back into the Spryte until it clicks. Note: when inserting a new coil and filling the pod, always let the device stand for 5 minutes to allow the coil to become saturated. This will help avoid dry hits and damage to the coil.
Filling
Refilling the pod is super easy. Remove the pod from the device, invert the pod and remove the silicone plug from the 4.6 diameter filling hole. Fill the pod with e-liquid, and replace the silicone plug securely. Replace the pod into the device by pushing down until it clicks into place, and it’s ready.
Charging
Charging the Aspire Spryte is also very simple. Just plug in the supplied micro usb cable into the base of the mod, attach the other end to a suitable power supply to charge. The maximum charge current can reach up to 1000mA. When attached to the usb with the power on the LEDs will flash blue and red three times, when fully charges the LEDs will flash blue and red twenty times then remain off.
For more info: Click here